The Challenges to Swim Spa Covers

Swim Spas represent distinct obstacles when it comes to covering them.
We can all concur that the swim spa has to be covered when not in use for all the same reasons a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, removing and replacing the cover can be a lot more difficult.
Getting a brand-new swim spa is an amazing occasion in life. You’re looking forward to the exercise you’ll receive from using it. Perhaps you’re a little relieved to have actually lastly made a selection from the different designs you looked at. At any rate, you probably weren’t believing much about the cover you would use.
Generally, the cover that comes home with your new purchase will be a four section stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style defect. Built in obsolescence due to the fact that as quickly as it is positioned in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper will not make any difference. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are extremely little as they rise from the water surface. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.

It happens slowly and on a Swim Spa Cover which is made of specific areas, at varying speeds. So ultimately you’ll see a couple of of the sections are actually getting heavy. The bar lifters on the ends of the swim spa aren’t much aid because you still have to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com developed a different style for their Swim Spa Covers
Instead of using several foam panels to build Swim Spa Covers that will ultimately wind up in some landfill, they created one that utilizes air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or fall apart at the joints either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to order today, bookmark this website so you can discover it once again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *